An optional Heavy Duty Load Spreading Bridge directs reaction loads away from the fixing while the accompanying Pulling Frame enables fixings to be tested in a realistic condition to demonstrate first movement and clamping force.

Load application is achieved via a ratchet handle driving a 4:1 hydraulic multiplier; the applied load being recorded directly on a gauge mounted on the tester body. This results in a compact design which is lighter and more convenient to use than separate hydraulic pump and ram arrangements.

Integral movement indication is provided allowing "First movement" to be identified as well as total displacement before failure.

	Calibration in kN.
	Shatterproof Glass.
	Maximum load indicator.

	Rubber shock proof casing.
	Red sector warning protects against over load.
	Built in protection against sudden load release.
	Calibration certificate supplied with every gauge.

Tester Features

	Accepts M24 anchors direct, other sizes via adaptors.
	4 Threaded adaptors supplied: M12, M16, M20, M24
	Movement indicator scale (10mm movement limit)
	0-30 and 0-90kN ranges, gauge divisions 5kN.
	Ratchet handle operation for reduced effort.
	2 gauges supplied as standard.
	Quick release gauge couplings.
	Weight: 7.0kg.

Proof and failure load testing of fixing types:

	High Load Expanding and Resin anchors.
	Cast-in Sockets and Channel.
	Holding down bolts for Stanchion base plates, Machinery, Crane rails, etc.
	Anchorages for Crash Barriers and Safety Fences.
	Anchorages for lifting equipment.
	Anchorages for Stadium Crush Barriers.
	Structural connections, Cladding fixings, etc.

	Square hollow section for high strength/low weight.
	Fixing to support distance = 200mm, meeting the spacing requirements of BS 5080 Pt 1 for anchors with hole diameters to 25mm and embedment depths to 100mm. Tests most M16, M20 and some M24 anchors to the BS.
	May be attached to Tester.

Detailed specification sheet available

Pulling Frame

	Allows demonstration of first movement and clamping force.
	Accepts anchors with sleeve diameters of 33mm directly and smaller diameters via plain adaptors.
	4 plain adaptors to suit M10 to M24 anchors.